Trash Chutes

Midland Chutes are fully factory assembled with all joints welded or lock seamed. There is one expansion joint per floor. All chutes have a flush interior and are assembled without bolts, rivets or clips protruding into the chute opening. Chutes are equipped with chute support clips pre-positioned at the factory to insure proper chute alignment. The adjustable intake door and frame are securely fastened to the intake throat. If required, off-sets will be reinforced and supported in impact areas.

Our Basic Chute Contains:

Intake section(s) with specified door installed on unit.

Spiralled expansion section(s) to make up the balance of floor height.

Angle iron floor brace(s) to support the chute.

Outlet door equipped with a 165┬░ fusible link to close in case of fire.

Full diameter vent in accordance with NFPA-82 Standards, to extend four feet above roof level.

Sprinkler and flushing head at the top of the chute with additional sprinkler heads at every other floor.